DTC P117A:00 [PCM (SKYACTIV-D 2.2)]

id0102j5316900

DTC P117A:00

Record of torque restriction for piston protection
DETECTION CONDITION
•  The engine oil pressure is the specified value or less for a continuous 8 s.
Diagnostic support note
•  This is a continuous monitor (other).
•  The check engine light does not illuminate.
•  FREEZE FRAME DATA/Snapshot data is not available.
•  DTC is not stored in the PCM memory.
FAIL-SAFE FUNCTION
Not applicable
POSSIBLE CAUSE
•  Engine oil pressure is low.
•  Engine oil temperature is high.
•  High engine speed condition is continued with the engine oil diluted.
•  Engine oil pressure sensor malfunction
•  PCM malfunction
SYSTEM WIRING DIAGRAM
Not applicable

Diagnostic Procedure

STEP

INSPECTION

ACTION
1
VERIFY RELATED SERVICE INFORMATION AVAILABILITY
•  Verify related Service Information availability.
•  Is any related Service Information available?
Yes
Perform repair or diagnosis according to the available Service Information.
•  If the vehicle is not repaired, go to the next step.
No
Go to the next step.
2
VERIFY RELATED PENDING CODE AND/OR DTC
•  Switch the ignition off, then ON (engine off).
•  Perform the Pending Trouble Code Access Procedure and DTC Reading Procedure.
•  Are any other PENDING CODEs and/or DTCs present?
Yes
Go to the applicable PENDING CODE or DTC inspection.
(See DTC TABLE [PCM (SKYACTIV-D 2.2)].)
No
Go to the next step.
3
INSPECT EFFECT OF VEHICLE CONDITION FOR MALFUNCTION
•  Verify how the customer drives the vehicle by asking the customer the following:
―  Continue the high engine speed condition with the message related to a diesel particulate filter malfunction in the display. (With center display or type A instrument cluster)
―  Continue the high engine speed condition with the diesel particulate filter indicator light illuminated.
•  Is the use situation as indicated above?
Yes
Explain to the customer that the vehicle is normal. (malfunction caused by driving at high engine speed with engine oil diluted)
If there is a concern with customer’s driving, provide the customer some pertinent advice (such as gear selection, how to use manual mode).
Go to Step 6.
No
Go to the next step.
4
INSPECT ENGINE OIL LEAKAGE
•  Start the engine.
•  Visually inspect the engine oil runner for engine oil leakage.
•  Is there any leakage?
Yes
Repair or replace the malfunctioning part, add genuine engine oil, then go to Step 6.
No
Go to the next step.
5
INSPECT ENGINE OIL PRESSURE SENSOR
•  Inspect the engine oil pressure sensor.
•  Is there any malfunction?
Yes
Replace the engine oil temperature sensor/engine oil pressure sensor, then go to the next step.
(See ENGINE OIL TEMPERATURE SENSOR/ENGINE OIL PRESSURE SENSOR REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)
No
Go to the next step.
6
VERIFY DTC TROUBLESHOOTING COMPLETED
•  Clear the DTC from the PCM memory using the M-MDS.
•  Start the engine and warm it up completely.
•  Drive the vehicle.
•  Perform the DTC Reading Procedure.
•  Is the same DTC present?
Yes
Repeat the inspection from Step 1.
•  If the malfunction recurs, replace the PCM.
Go to the next step.
No
Go to the next step.
7
VERIFY AFTER REPAIR PROCEDURE
•  Perform the “AFTER REPAIR PROCEDURE”.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [PCM (SKYACTIV-D 2.2)].)
No
DTC troubleshooting completed.