CRANKSHAFT POSITION (CKP) SENSOR INSPECTION [SKYACTIV-D 2.2]

id0140z7800500

Visual Inspection

Caution

•  When foreign material such as an iron chip is on the CKP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect the engine control. Be sure there is no foreign material on the CKP sensor when replacing.

1.  Turn the steering wheel to full right lock.

2.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

3.  Lift up the vehicle.

4.  Remove the front splash shield. (See SPLASH SHIELD REMOVAL/INSTALLATION.)

5.  Disconnect the CKP sensor connector.

6.  Remove the CKP sensor. (See CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

7.  Verify that there are no metal shavings on the CKP sensor.

•  If there is a malfunction, remove any metal shavings that are adhering.

Voltage Inspection

Caution

•  When foreign material such as an iron chip is on the CKP sensor, it can cause abnormal output from the sensor because of flux turbulence and adversely affect the engine control. Be sure there is no foreign material on the CKP sensor when replacing.

•  If the wiring harnesses or waterproof connectors are damaged, water penetrating the connector will cause a sensor malfunction. To prevent this, be careful not to damage wiring harnesses or waterproof connectors.

1.  Idle the engine.

2.  Measure the CKP sensor output voltage wave pattern using an oscilloscope.

•  If not as specified, replace the CKP sensor. (See CRANKSHAFT POSITION (CKP) SENSOR REMOVAL/INSTALLATION [SKYACTIV-D 2.2].)

ac5wzw00005516

•  Specification

4.5 V or more (Maximum value of wave pattern)

0.8 V or less (Minimum value of wave pattern)

Wave pattern (reference)

am6zzw00012654

Oscilloscope setting

•  3 V/DIV (Y), 1 ms/DIV (X), DC range

Vehicle condition

•  Idle after warm up