COUPLING COMPONENT CALIBRATION DATA WRITING

id031800806200

1.  Connect the M-MDS to the DLC-2.

2.  After the vehicle is identified, select the following items from the toolbox of the M-MDS.

1.  Select “Chassis”.

3.  Then, select items from the screen menu in the following order.

1.  Select “4WD/AWD”.

2.  Select “Coupling Calibration Data Writing”.

4.  Perform the Coupling calibration data writing according to the directions on the screen.

5.  Verify all the DTCs for the control module connected to the CAN line.

•  If any DTC is stored, clear it.

•  If the DTC is cleared, finish the procedure because the calibration data writing is completely normally.

•  If the DTC remains, perform troubleshooting according to the DTC.