FRONT ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION

id041500800300

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Remove the wheel and tire. (See WHEEL AND TIRE REMOVAL/INSTALLATION.)

3.  Remove in the order indicated in the table.

4.  Install in the reverse order of removal.

5.  After installation, verify that there is no twisting in the front ABS wheel-speed sensor.

am3zzw00019819

1	Connector (See Connector Disconnection Note.)
2	Bolt
3	Front ABS wheel-speed sensor (See Connector Disconnection Note.)

Connector Disconnection Note

1.  Peel back the front mudguard and disconnect the connector. (See MUDGUARD REMOVAL/INSTALLATION.)

Front ABS Wheel-speed Sensor Wiring Harness and Clip Disconnection Note

Note

•  Refer to this note only if the disconnection of the front ABS wheel-speed sensor wiring harness and the clip shown in the figure is required.

am3zzw00019810

1.  Insert a flathead screwdriver from the side where there is no notch as shown in the figure.

am3zzw00019811

2.  Detach the tab as shown in the figure and disconnect the front ABS wheel-speed sensor wiring harness and clip.

am3zzw00019812