REFRIGERANT PRESSURE SENSOR REMOVAL/INSTALLATION [MANUAL AIR CONDITIONER]

id0740a2817300


SKYACTIV-G 2.0, SKYACTIV-G 2.5

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].)(See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)

2.  Discharge the refrigerant. (See REFRIGERANT RECOVERY.)(See REFRIGERANT CHARGING.)

3.  Disconnect the refrigerant pressure sensor connector.

am6zzw00012981

4.  Loosen the refrigerant pressure sensor using two spanners.

am6zzw00010754

Tightening torque
10—11 N·m {102—112 kgf·cm, 89—97 in·lbf}

5.  Remove the refrigerant pressure sensor.

am6zzw00012982

Caution
•  If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.

6.  Install in the reverse order of removal. (See Refrigerant Pressure Sensor Installation Note.)

7.  Perform the refrigerant system performance test. (See REFRIGERANT SYSTEM PERFORMANCE TEST.)


SKYACTIV-D 2.2

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Discharge the refrigerant. (See REFRIGERANT RECOVERY.)(See REFRIGERANT CHARGING.)

3.  Disconnect the connector.

am6zzw00012983

4.  Remove the fastener.

5.  Remove the bolts.

6.  Set the PCM out of the way.

am6zzw00010757

7.  Disconnect the refrigerant pressure sensor connector.

am6zzw00012981

8.  Loosen the refrigerant pressure sensor using two spanners.

am6zzw00010754

Tightening torque
10—11 N·m {102—112 kgf·cm, 89—97 in·lbf}

9.  Remove the refrigerant pressure sensor.

am6zzw00012982

Caution
•  If moisture or foreign material enters the refrigeration cycle, cooling ability will be lowered and abnormal noise will occur. Always immediately plug all open fittings after removing any refrigeration cycle parts to keep moisture or foreign material out of the cycle.

10.  Install in the reverse order of removal. (See Refrigerant Pressure Sensor Installation Note.)

11.  Perform the refrigerant system performance test. (See REFRIGERANT SYSTEM PERFORMANCE TEST.)


Refrigerant Pressure Sensor Installation Note

1.  Apply compressor oil to the O-rings and connect the joints.