ACTIVE DRIVING DISPLAY IS NOT SET TO CORRECT POSITION [INSTRUMENT CLUSTER]

id0903d5025000

Note

• If there is any vehicle malfunction complaint lodged by a customer, perform FOREWORD [INSTRUMENT CLUSTER] malfunction diagnosis according to the troubleshooting procedure. (See FOREWORD [INSTRUMENT CLUSTER].)

Possible Cause

• Angle of the combiner is deviated (combiner open/close angle may deviate if foreign matter penetrates while it is opening/closing)

• Active driving display malfunction

• Instrument cluster malfunction

Diagnostic Procedure

Step

Inspection

Action

1

VERIFY THE COMBINER OPEN/CLOSE CONDITION

•  Switch the ignition OFF.

•  Verify the combiner open/close condition.

•  Does the combiner partially open?

Yes

Perform the combiner angle initial setting.

(See ACTIVE DRIVING DISPLAY INSPECTION.)

No

Go to the next step.

2

VISUALLY INSPECT ACTIVE DRIVING DISPLAY

•  Switch the ignition ON (engine on).

•  Visually inspect the active driving display for damage, dust, or dirt.

•  Is there damage, foreign matter penetration, or dirt on the active driving display?

Yes

If the active driving display is damaged:

•  Replace the active driving display.
(See ACTIVE DRIVING DISPLAY REMOVAL/INSTALLATION.)

If there is foreign matter penetration or dirt on the active driving display:

•  Remove foreign matter or dirt on the active driving display.

No

Go to the next step.

3

INSPECT ACTIVE DRIVING DISPLAY

•  Inspect the active driving display.
(See ACTIVE DRIVING DISPLAY INSPECTION.)

•  Is the active driving display normal?

Yes

Go to the next step.

No

Replace the active driving display.

(See ACTIVE DRIVING DISPLAY REMOVAL/INSTALLATION.)

4

VERIFY IF MALFUNCTION CAUSE IS CORRECTED

•  Is the active driving display operating normally?

Yes

Troubleshooting completed (explain the contents of the servicing to the customer).

No

Replace the instrument cluster.

(See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)

Step	Inspection	Action
1	VERIFY THE COMBINER OPEN/CLOSE CONDITION • Switch the ignition OFF. • Verify the combiner open/close condition. • Does the combiner partially open?	Yes	Perform the combiner angle initial setting. (See ACTIVE DRIVING DISPLAY INSPECTION.)
1		No	Go to the next step.
2	VISUALLY INSPECT ACTIVE DRIVING DISPLAY • Switch the ignition ON (engine on). • Visually inspect the active driving display for damage, dust, or dirt. • Is there damage, foreign matter penetration, or dirt on the active driving display?	Yes	If the active driving display is damaged: • Replace the active driving display. (See ACTIVE DRIVING DISPLAY REMOVAL/INSTALLATION.) If there is foreign matter penetration or dirt on the active driving display: • Remove foreign matter or dirt on the active driving display.
2		No	Go to the next step.
3	INSPECT ACTIVE DRIVING DISPLAY • Inspect the active driving display. (See ACTIVE DRIVING DISPLAY INSPECTION.) • Is the active driving display normal?	Yes	Go to the next step.
3		No	Replace the active driving display. (See ACTIVE DRIVING DISPLAY REMOVAL/INSTALLATION.)
4	VERIFY IF MALFUNCTION CAUSE IS CORRECTED • Is the active driving display operating normally?	Yes	Troubleshooting completed (explain the contents of the servicing to the customer).
4		No	Replace the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION.)