AUDIO UNIT DISPLAY NOT DISPLAYED [ENTERTAINMENT SYSTEM [WITHOUT CENTER DISPLAY]]
id0903l9061900
Description
|
AUDIO UNIT DISPLAY NOT DISPLAYED
|
Does not display even with the audio unit power turned on
|
|
Possible Causes
|
• Connector poor contact or terminal damage
• Open circuit in wiring harness between audio unit terminal 1W and body ground
• Audio unit malfunction
|
Diagnostic Procedure
Step |
Inspection |
Action |
|
---|---|---|---|
1
|
INSPECT AUDIO UNIT CONNECTOR
• Switch the ignition off.
• Disconnect the negative battery cable.
• Disconnect the audio unit connector.
• Inspect the connector engagement and connection condition and inspect the terminals for damage, deformation, corrosion, or disconnection.
• Is the connector normal?
|
Yes
|
Go to the next step.
|
No
|
Repair or replace the connector, then go to Step 3.
|
||
2
|
VERIFY IF MALFUNCTION CAUSE IS OPEN CIRCUIT IN WIRING HARNESS BETWEEN AUDIO UNIT AND BODY GROUND
• Verify that the audio unit connectors are disconnected.
• Inspect the wiring harness for continuity between audio unit terminal 1W and body ground (vehicle wiring harness side).
• Is there continuity?
|
Yes
|
Replace the audio unit, then go to the next step.
|
No
|
• Refer to the wiring diagram and verify if there is a common connector between audio unit terminal 1W and body ground.
If there is a common connector:
If there is no common connector:
• Go to the next step.
|
||
3
|
VERIFY IF MALFUNCTION CAUSE IS CORRECTED
• Connect the audio unit connector.
• Reconnect the negative battery cable.
• Switch the ignition to ACC or ON (engine off or on).
• Press the POWER/VOLUME button to turn on the audio unit power.
• Does the display of the audio unit display images?
|
Yes
|
Troubleshooting completed. (Explain the contents of the servicing to the customer.)
|
No
|
Verify the malfunction symptom in the symptom troubleshooting chart and perform the other applicable malfunction diagnosis.
|