HAZARD WARNING SWITCH INSPECTION

id091800803100

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Remove the following parts:

(1)  Upper column cover (See COLUMN COVER REMOVAL/INSTALLATION.)

(2)  Meter hood (See METER HOOD REMOVAL/INSTALLATION.)

(3)  Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)

(4)  Decoration panel (passenger-side) (See DECORATION PANEL REMOVAL/INSTALLATION.)

3.  Verify that the continuity between the hazard warning switch terminals is as indicated in the table.

am6zzw00008069

am6zzw00008070

•  If the continuity is as indicated in the table, go to the next step.

•  If not as indicated in the table, replace the hazard warning switch. (See HAZARD WARNING SWITCH REMOVAL/INSTALLATION.)

4.  Apply battery voltage to hazard warning switch terminal A, and connect terminal B to ground.

am6zzw00014021

5.  Verify that the LED illuminates.

•  If the LED does not illuminate, replace the hazard warning switch. (See HAZARD WARNING SWITCH REMOVAL/INSTALLATION.)