INSTRUMENT CLUSTER INSPECTION

id092200010600

Speedometer inspection

Using a speedometer tester

Caution

• When only the front or the rear wheels are driven using a speedometer tester, the DSC HU/CM may determine that the vehicle speed signal is in error and the engine cannot be stopped by the normal operation. If the engine cannot be stopped, perform an emergency engine stop operation. (See SERVICE CAUTIONS.)

1. Adjust the tire pressure to the specification.

2. Using a speedometer tester, verify that the tester reading is as indicated in the following table.

European (L.H.D. U.K.), General (L.H.D. R.H.D.) specs., Australian specs.

Speedometer tester indication (km/h)	Allowable range (km/h)
20	20.40—25.26
40	40.80—45.46
60	61.20—65.06
80	81.60—86.66
100	102.00—107.76
120	122.40—129.08
140	142.80—150.28
160	163.20—170.66
180	183.60—191.08
200	204.00—211.74
220	224.40—234.76
240	244.80—253.16

U.K. specs.

Speedometer tester indication (mph)	Allowable range (mph)
10	10.20—13.20
20	20.40—23.30
30	30.60—33.60
40	40.80—43.90
50	51.00—54.28
60	61.20—64.88
70	71.40—75.56
80	81.60—86.12
90	91.80—96.44
100	102.00—106.64
110	112.20—116.84
120	122.20—127.00
130	132.60—137.80
140	142.80—148.00
150	153.00—158.20

General (L.H.D. R.H.D.) specs.

Speedometer tester indication (km/h)	Allowable range (km/h)
20	20.40—25.00
40	40.80—45.50
60	61.20—66.00
80	81.60—86.60
100	102.00—107.50
120	122.40—128.40
140	142.80—149.30
160	163.20—170.20
180	183.60—190.60
200	204.00—211.50
220	224.40—232.40
240	244.80—252.80

3. Verify that the speedometer reading is within the range indicated in the table.

• If the speedometer does not operate or the indication is not within the allowable range, inspect the DTC inspection for the following control module and the related wiring harnesses.

― PCM

― TCM (ATX)

― DSC HU/CM

• If the PCM, TCM (ATX), DSC HU/CM, and related wiring harnesses are normal, replace the instrument cluster.

Using the M-MDS

1. Connect the M-MDS to the DLC-2.

2. After vehicle identification, select the following from the M-MDS initialization screen.

(1) “Data logger”

(2) “Module”

(3) “IC”

3. Using “SPEEDOMTR”, verify that the displayed information is as indicated in the table.

European (L.H.D. U.K.), General (L.H.D. R.H.D.) specs., Australian specs.

M-MDS display	Speedometer display
60 km/h	Speedometer needle moves to approx. 61—67 km/h {38—42 mph}.
120 km/h	Speedometer needle moves to approx. 122—130 km/h {75—81 mph}.
Off	Speedometer needle moves to the bottommost position.

General (L.H.D. R.H.D.) specs.,

M-MDS display	Speedometer display
60 km/h	Speedometer needle moves to approx. 57—63 km/h {35—40 mph}.
120 km/h	Speedometer needle moves to approx. 116—124 km/h {72—77 mph}.
Off	Speedometer needle moves to the bottommost position.

• If the speedometer does not operate or the indication is not within the allowable range, inspect the DTC inspection for the following control module and the related wiring harnesses.

― PCM

― TCM (ATX)

― DSC HU/CM

• If the PCM, TCM (ATX), DSC HU/CM, and related wiring harnesses are normal, replace the instrument cluster.

Tachometer inspection

Caution

• If the engine speed exceeds the allowable range, the engine could be damaged. Therefore, when inspecting the tachometer, do not allow the engine speed to exceed the allowable range indicated on the tachometer.

1. Connect the M-MDS to the DLC-2.

2. After vehicle identification, select the following from the M-MDS initialization screen.

(1) “Data logger”

(2) “Module”

(3) “IC”

3. Using “TACHOMTR”, verify that the displayed information is as indicated in the table.

M-MDS display

Tachometer display

3000 RPM

Tachometer needle moves to approx. 3,050 rpm.

6000 RPM

Tachometer needle moves to approx. 6,100 rpm.

Off

Tachometer needle moves to bottommost position.

• If the tachometer does not operate or the indication is not within the allowable range, inspect the DTC inspection for the following control module and the related wiring harnesses.

― PCM

• If the PCM and related wiring harnesses are normal, replace the instrument cluster.

LCD Inspection

Type A

1. Connect the M-MDS to the DLC-2.

2. After vehicle identification, select the following from the M-MDS initialization screen.

(1) “Data logger”

(2) “Module”

(3) “IC”

3. Using “LCD_SEG”, verify that the LCD is illuminated.

am6zzw00015289

• If there are any non-illuminated area, replace the instrument cluster.

Type B

1. Connect the M-MDS to the DLC-2.

2. After vehicle identification, select the following from the M-MDS initialization screen.

(1) “Data logger”

(2) “Module”

(3) “IC”

3. Using “LCD_SEG”, verify that the LCD is illuminated.

• If there are any non-illuminated area, replace the instrument cluster.

am6zzw00015290

Warning/Indicator Light Illumination Inspection

1. Connect the M-MDS to the DLC-2.

2. After vehicle identification, select the following from the M-MDS initialization screen.

(1) “Data logger”

(2) “Module”

(3) “IC”

3. Using “WL+IL”, verify that the warning/indicator lights in the following table are illuminated.

• If any of the warning/indicator lights are not displayed, replace the instrument cluster.

Without multi-information display

am6zzn00004742

×: Applicable

—: Not applicable

No.	Name	Message is displayed in center display when warning/indicator light turns on/flashes	Comment	Warning/indicator light turned on when ignition is switched ON (engine off or on)
1	Check engine light	×	—	×
2	Tire pressure monitoring system warning light	×	With tire pressure monitoring system	×
3	Automatic transaxle warning light	×	ATX	×
4	Diesel particulate filter indicator light	×	SKYACTIV-D 2.2	×
5	ABS warning light	×	—	×
6	Blind spot monitoring (BSM) OFF indicator light	×	With blind spot monitoring (BSM) system	×
7	Smart brake support/smart city brake support (SBS/SCBS) OFF indicator light	—	With smart city brake support (SCBS) or smart brake support (SBS)	×
8	TCS OFF indicator light	—	—	×
9	Turn signal/hazard warning indicator lights	—	—	—
10	i-ELOOP indicator light (green)/i-ELOOP warning light (amber)	×	With i-ELOOP	×
11	LED headlight warning light	×	With headlight (LED type)	×
12	Engine oil warning light	×	—	×
13	Security indicator light	—	—	×
14	KEY warning light (red)/KEY indicator light (green)	×	—	×
15	Seat belt warning light	—	—	—
16	Charging system warning light	×	—	×
17	Low washer fluid level warning light	×	With washer fluid-level sensor	—
18	Lane-keep assist system warning light/LDWS warning light	×	With lane departure warning system (LDWS) or lane-keep assist system	×
19	Smart brake support/smart city brake support (SBS/SCBS) indicator light/Smart brake support/smart city brake support (SBS/SCBS) warning light	×	With smart city brake support (SCBS) or smart brake support (SBS)	×
20	Master warning light	×	—	×
21	Wrench indicator light	×	—	×
22	Low fuel warning light	×	—	—
23	Rear fog light indicator light	—	With rear fog light	—
24	Front fog lights indicator light	—	With front fog light	—
25	Brake pedal operation demand indicator light	—	—	×
26	120 km/h warning light	×	With 120 km/h warning light	×
27	Door-ajar warning light	—	—	—
28	Brake system warning light	×	—	×
29	Headlight high-beam indicator light	—	—	—
30	Electric parking brake indicator light	—	—	×
31	Electric parking brake warning light	—	—	×
32	Air bag/seat belt pretensioner system warning light	×	—	×
33	Lights-on indicator light	—	—	—
34	HBC indicator light (green)/HBC warning light (amber)/Adaptive LED headlights indicator light (green)/adaptive LED headlights warning light (amber)	×	With high beam control (HBC) system or adaptive LED headlights	×
35	i-stop warning light (amber)/i-stop indicator light (green)	×	With i-stop system	×
36	Lane-keep assist system OFF indicator light/LDWS OFF indicator light	×	With lane departure warning system (LDWS) or lane-keep assist system	—
37	Glow indicator light	×	SKYACTIV-D 2.2	×
38	4WD warning light	×	4WD	×
39	Power steering malfunction indicator light	×	—	×
40	TCS/DSC indicator light	×	—	×

With multi-information display

am6zzw00015291

×: Applicable

—: Not applicable

No.	Name	Message is displayed in multi-information display when warning/indicator light turns on/flashes	Message is displayed in center display when warning/indicator light turns on/flashes	Comment	Warning/indicator light turned on when ignition is switched ON (engine off or on)
1	ABS warning light	—	×	—	×
2	Electric parking brake warning light	×	—	—	—
3	Check engine light	—	×	—	×
4	Engine oil level warning light	×	×	—	—
5	Blind spot monitoring (BSM) OFF indicator light	—	×	With blind spot monitoring (BSM) system	—
6	Smart brake support/smart city brake support (SBS/SCBS) OFF indicator light	—	—	With smart city brake support (SCBS) or smart brake support (SBS)	×
7	TCS OFF indicator light	—	—	—	×
8	Turn signal/hazard warning indicator lights	—	—	—	—
9	Glow indicator light	—	×	SKYACTIV-D 2.2	×
10	120 km/h warning light	—	×	With 120 km/h warning light	×
11	Headlight high-beam indicator light	—	—	—	—
12	Electric parking brake indicator light	—	×	—	—
13	Air bag/seat belt pre-tensioner system warning light	—	×	—	—
14	Security indicator light	—	—	—	×
15	Low engine coolant temperature indicator light (blue)/high engine coolant temperature warning light (red)	×	×	—	×
16	Rear fog light indicator light	—	—	With rear fog light	—
17	Front fog lights indicator light	—	—	With front fog light	—
18	Brake system warning light	×	×	—	×
19	Charging system warning light	×	×	—	×
20	Seat belt warning light	—	—	—	—
21	Engine oil warning light	×	×	—	×
22	Lights-on indicator light	×	—	—	—
23	HBC indicator light (green)/HBC warning light (amber)/Adaptive LED headlights indicator light (green)/adaptive LED headlights warning light (amber)	—	×	With high beam control (HBC) system or adaptive LED headlights	×
24	i-stop warning light (amber)/i-stop indicator light (green)	×	×	With i-stop system	×
25	Lane-keep assist system OFF indicator light/LDWS OFF indicator light	—	×	With lane departure warning system (LDWS) or lane-keep assist system	—
26	TCS/DSC indicator light	—	×	—	×
27	LED headlight warning light	—	×	With headlight (LED type)	—
28	Tire pressure monitoring system warning light	×	×	With tire pressure monitoring system	×

Alarm Inspection

1. Connect the M-MDS to the DLC-2.

2. After vehicle identification, select the following from the M-MDS initialization screen.

(1) “Data logger”

(2) “Module”

(3) “IC”

3. Using “ALARM”, verify that the buzzer sounds.

• If the buzzer does not sound, replace the instrument cluster.

M-MDS display	Tachometer display
3000 RPM	Tachometer needle moves to approx. 3,050 rpm.
6000 RPM	Tachometer needle moves to approx. 6,100 rpm.
Off	Tachometer needle moves to bottommost position.