DTC INSPECTION [DYNAMIC STABILITY CONTROL (DSC)]

id0402b2866500

CMDTC Self Test

1.  Connect the M-MDS to the DLC-2.

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

(1)  Select “Self Test”.

(2)  Select “All CMDTCs”.

3.  Verify the DTC according to the directions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)].)

Note

•  Snapshot data appears at the top of the help screen when the displayed DTC is selected.

•  Snapshot data stores the currently detected DTC data.

4.  After completion of repairs, clear all DTCs stored in the module. (See CLEARING DTC [DYNAMIC STABILITY CONTROL (DSC)].)

ODDTC Self Test

1.  Connect the M-MDS to the DLC-2.

2.  After the vehicle is identified, select the following items from the initialization screen of the M-MDS.

(1)  Select “Self Test”.

(2)  Select “Modules”.

(3)  Select “ABS”.

3.  Verify the DTC according to the directions on the screen.

•  If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)].)

4.  After completion of repairs, clear all DTCs stored in the module. (See CLEARING DTC [DYNAMIC STABILITY CONTROL (DSC)].)

Snapshot Data Table

Note

•  The DSC HU/CM stores the following two types of information when a DTC is detected and displays snap shot data in the M-MDS.

―  Vehicle information detected by DSC HU/CM

―  Vehicle information detected by instrument cluster and received by start stop unit via CAN signal

•  Refer to PID monitor table for confirm the laser sensor system operation status while the laser sensor does not store the DTC. (See PID/DATA MONITOR TABLE [DYNAMIC STABILITY CONTROL (DSC)].)

•  Snapshot data items are not displayed, according to detected DTC.