UP SWITCH INSPECTION [FW6A-EL]

id0517h1600500


Continuity Inspection

Note
•  The up switch is built into the selector lever component.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)

2.  Remove the following parts:

(1)  Selector lever knob (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)
(2)  Upper panel (See UPPER PANEL REMOVAL/INSTALLATION.)
(3)  Rear console (See REAR CONSOLE REMOVAL/INSTALLATION.)
(4)  Console side panel (See CONSOLE SIDE PANEL REMOVAL/INSTALLATION.)
(5)  Shift panel (See SHIFT PANEL REMOVAL/INSTALLATION.)
(6)  Front console box (See FRONT CONSOLE BOX REMOVAL/INSTALLATION.)
(7)  CD player (with CD player) (See CD PLAYER REMOVAL.) (See CD PLAYER INSTALLATION.)
(8)  DVD/CD player (with DVD/CD player) (See DVD/CD PLAYER REMOVAL.) (See DVD/CD PLAYER INSTALLATION.)
(9)  Side wall (See SIDE WALL REMOVAL/INSTALLATION.)
(10)  Front console (See FRONT CONSOLE REMOVAL/INSTALLATION.)

3.  Disconnect the selector lever component connector.

ac5uuw00003544

4.  Verify that the continuity between selector lever component terminals C and J.

am6zzw00012081

•  If not as verified, replace the selector lever component. (See AUTOMATIC TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION.)

Up switch specification

Test condition

Continuity
Selector lever is in the M position (+) side position.
Continuity
Selector lever is not in the M position (+) side position.
No continuity