AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT [GW6A-EL, GW6AX-EL]

id0517i2118600

Warning
•  Do not perform the servicing while the ATF is hot. Otherwise, it could cause severe burns or serious injury.

1.  Remove the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)

2.  Disconnect the wiring harness from the front crossmember. (Vehicle with i-ELOOP)

am6zzw00008996

3.  Disconnect the oil pipe No.1 from the harness bracket with the oil hose connected. (With Oil cooler No.2)

ac5wzw00003744

4.  Remove the dipstick securing bolt.

5.  Remove the dipstick.

ac5wzw00003607

6.  Remove the drain plug and washer, and drain the ATF.

7.  Install a new washer and drain plug.

Tightening torque
30—41 N·m {3.1—4.1 kgf·m, 23—30 ft·lbf}

8.  Add ATF from the dipstick installation hole.

Note
•  The ATF color is blue.
•  Only use ATF FZ for the GW6A-EL, GW6AX-EL.
am3zzw00012640

ATF type

Resupply amount (Reference)
ATF FZ
ATF is drained from drain plug: 3.5—4.9 L {3.7—5.1 US qt, 3.1—4.3 Imp qt}

9.  Adjust the ATF level. (See AUTOMATIC TRANSAXLE FLUID (ATF) ADJUSTMENT [GW6A-EL, GW6AX-EL].)

10.  Insert the dipstick and install the securing bolt.

Tightening torque
8—11 N·m {82—112 kgf·cm, 71—97 in·lbf}

11.  Install the oil pipe No.1 to the harness bracket. (With Oil cooler No.2)

ac5wzw00003747

12.  Connect the wiring harness to the front crossmember. (Vehicle with i-ELOOP)

am6zzw00008996

13.  Install the front under cover No.2. (See FRONT UNDER COVER No.2 REMOVAL/INSTALLATION.)