i-ELOOP INDICATION/i-ELOOP INDICATOR LIGHT (GREEN) [i-ELOOP]

id131704501500


Purpose

•  The i-ELOOP indication/i-ELOOP indicator light (green) notifies the user that the i-ELOOP operation condition is in pre-charge mode or regenerative braking mode.

Function

•  The PCM sends an i-ELOOP indicator light (green) illumination request signal/i-ELOOP indication request signal to the instrument cluster.
•  When the instrument cluster receives a i-ELOOP indicator light (green) illumination request signal/i-ELOOP indication request signal sent from the PCM via CAN communication, it turns the i-ELOOP indicator light (green) on or displays the i-ELOOP indication.

Construction

•  The i-ELOOP indication or i-ELOOP indicator light (green) is built into the instrument cluster.
am6zzn00004759
•  For vehicles equipped with the multi-information display, a warning message is displayed in the multi-information display as the same time the wrench indicator light is turned on/wrench indication is displayed. For the message content and verification method, refer to [MULTI-INFORMATION DISPLAY]. (See MULTI-INFORMATION DISPLAY.)
•  For vehicles with the center display, a warning message in the center display is displayed when the i-ELOOP warning indication displays. For the message content and verification method, refer to the [CENTER DISPLAY]. (See CENTER DISPLAY [WITH CENTER DISPLAY].)

Operation


i-ELOOP indicator light (green)

•  The i-ELOOP indicator light illumination conditions are as follows:
i-ELOOP indicator light illumination conditions
―  i-ELOOP control is in regenerative braking mode
i-ELOOP indicator light flashing conditions
―  i-ELOOP control is in pre-charge mode

1.  When the ignition is switched ON (engine off or on), the instrument cluster receives (1) a i-ELOOP indicator light (green) illumination request signal from the PCM via CAN communication.

2.  The instrument cluster turns the transistor on (2) based on the i-ELOOP indicator light (green) illumination request signal.

3.  When the transistor turns on, a ground circuit with the i-ELOOP indicator light (green) is established and the i-ELOOP indicator light (green) turns on (3).

am6zzn00004760


i-ELOOP indication

•  The i-ELOOP indication conditions is as follow:
―  i-ELOOP control is in pre-charge mode

1.  When the ignition is switched ON (engine off or on), the instrument cluster receives (1) a i-ELOOP indication request signal from the PCM via CAN communication.

2.  The instrument cluster displays (2) the i-ELOOP indication in the multi-information display.

am6zzn00004761