CRUISE CONTROL SWITCH INSPECTION [SKYACTIV-D 2.2]

id0120e5800100

1.  Disconnect the negative battery cable and wait for 1 min or more. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL.) (See DRIVER-SIDE AIR BAG MODULE INSTALLATION.)

3.  Disconnect the clock spring connector (part wiring harness-side).

4.  Measure the resistance between clock spring terminals 3E and 3A (part wiring harness-side) using a ohmmeter.

am3zzw00018946

•  If as specified, go to the next step.

•  If not as specified, replace the steering switch. (See STEERING SWITCH REMOVAL/INSTALLATION.)

Switch condition	Resistance (ohm)
OFF/CANCEL switch held at on	Approx. 0
SET/− switch held at on	Approx. 84.5
RESUME/+ switch held at on	Approx. 189.5
ON switch held at on (without adjustable speed limiter) MODE switch held at on (with adjustable speed limiter)	Approx. 326.5
Neutral	Approx. 3,311.5

5.  Apply battery positive voltage to clock spring terminal 3F (part wiring harness-side), and terminal 3B (part wiring harness-side) to ground.

ac5wzw00000922

6.  Verify that the LED illuminates.

•  If the LED does not illuminate, replace the steering switch. (See STEERING SWITCH REMOVAL/INSTALLATION.)