DTC U0336:00 [DYNAMIC STABILITY CONTROL (DSC)]

id0402b2860900

DTC
U0336:00
Abnormal message from SAS control module
DETECTION CONDITION
•  Correct data cannot be received from SAS control module.
FAIL-SAFE FUNCTION
•  Refer to “Fail-safe Function Malfunction Contents”. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)].)
POSSIBLE CAUSE
•  SAS control module malfunction
SYSTEM WIRING DIAGRAM
—

Diagnostic procedure

STEP

INSPECTION

ACTION
1
VERIFY SAS CONTROL MODULE DTC
•  Using the M-MDS, perform the SAS control module DTC inspection.
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [SAS CONTROL MODULE].)
DTC troubleshooting completed, then go to the next step
No
Go to the next step.
2
VERIFY DTC TROUBLESHOOTING COMPLETED
•  Using the M-MDS, clear the DTC from the DSC HU/CM.
•  Using the M-MDS, perform the DSC HU/CM DTC inspection.
•  Is the same DTC present?
Yes
Repeat the inspection from Step1.
If the malfunction recurs, replace the SAS control module then go to the next step.
(See SAS CONTROL MODULE REMOVAL/INSTALLATION.)
No
Go to the next step.
3
VERIFY NO DTC IS PRESENT
•  Are any DTCs present?
Yes
Go to the applicable DTC inspection.
(See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)].)
No
DTC troubleshooting completed.