DTC U3000:96 [DYNAMIC STABILITY CONTROL (DSC)]
id0402b2880400
|
DTC
|
U3000:96
|
DSC HU/CM (internal malfunction)
|
|
|
DETECTION CONDITION
|
• The DSC HU/CM on-board diagnostic function detects control module internal malfunction.
|
||
|
FAIL-SAFE FUNCTION
|
• Refer to “Fail-safe Function Malfunction Contents”. (See DTC TABLE [DYNAMIC STABILITY CONTROL (DSC)].)
|
||
|
POSSIBLE CAUSE
|
• DSC HU/CM internal malfunction
|
||
|
SYSTEM WIRING DIAGRAM
|
—
|
||
Diagnostic procedure
|
STEP |
INSPECTION |
ACTION |
|
|---|---|---|---|
|
1
|
VERIFY DSC HU/CM DTC
• Using the M-MDS, clear the DTC from the DSC HU/CM.
• Start the engine and drive the vehicle at 10 km/h {6.2 mph} or more.
• Gradually slow down and stop vehicle.
• Using the M-MDS, perform the DSC HU/CM DTC inspection.
• Is the same DTC present?
|
Yes
|
Replace the DSC HU/CM, then go to the next step.
|
|
No
|
Go to the next step.
|
||
|
2
|
VERIFY NO DTC IS PRESENT
• Are any DTCs present?
|
Yes
|
Go to the applicable DTC inspection.
|
|
No
|
DTC troubleshooting completed.
|
||