AIR INTAKE ACTUATOR REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER]

id0740a1801400


L.H.D.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].)(See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)(See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Remove the following parts:

(1)  Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)
(2)  Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)
(3)  Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
(4)  Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
(5)  Tuner and amp unit (TAU) (With Tuner and amp unit (TAU)) (See TUNER AND AMP UNIT (TAU) REMOVAL/INSTALLATION.)

3.  Disconnect the air intake actuator connector.

am6zzw00010675

4.  Remove the screws, then remove the air intake actuator.

5.  Install in the reverse order of removal.


R.H.D.

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].)(See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)(See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].)

2.  Remove the following parts:

(1)  Passenger-side front scuff plate (See FRONT SCUFF PLATE REMOVAL/INSTALLATION.)
(2)  Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION.)
(3)  Glove compartment (See GLOVE COMPARTMENT REMOVAL/INSTALLATION.)
(4)  Dashboard under cover (See DASHBOARD UNDER COVER REMOVAL/INSTALLATION.)
(5)  Passenger-side lower panel (See LOWER PANEL REMOVAL/INSTALLATION.)
(6)  Passenger-side side wall (See SIDE WALL REMOVAL/INSTALLATION.)
(7)  Passenger-side front heat duct (See FRONT HEAT DUCT REMOVAL/INSTALLATION.)
(8)  Blower unit (See BLOWER UNIT REMOVAL/INSTALLATION.)

3.  Remove the screws, then remove the air intake actuator.

am6zzw00010676

4.  Install in the reverse order of removal.