CENTER ROOF ANTENNA INSPECTION

id092000801700

Note

•  The center roof antenna is integrated with the antenna amplifier.

Antenna amplifier inspection

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)

2.  Remove the following parts:

(1)  Rear seat cushon (See REAR SEAT CUSHION REMOVAL/INSTALLATION.)

(2)  Rear seat belt lower anchor installation bolt (See REAR SEAT BELT REMOVAL/INSTALLATION.)

(3)  Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION.)

(4)  Trunk side pocket (See TRUNK SIDE POCKET REMOVAL/INSTALLATION.)

(5)  Tunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION.)

(6)  Tunk side upper trim (See TRUNK SIDE UPPER TRIM REMOVAL/INSTALLATION.)

(7)  C-pillar trim (See C-PILLAR TRIM REMOVAL/INSTALLATION.)

(8)  D-pillar trim (See D-PILLAR TRIM REMOVAL/INSTALLATION.)

3.  Remove the rear passenger's assist handle. (See ASSIST HANDLE REMOVAL/INSTALLATION.)

4.  Remove the cargo net hook (with cargo net hook)(See HEADLINER REMOVAL/INSTALLATION.)

5.  Partially peel back the headliner.

Note

•  Be careful not to peel back the headliner excessively. Otherwise it could create a fold-seam in the headliner.

6.  Connect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)

7.  Switch the ignition ON (engine off).

8.  Turn the audio unit power on.

9.  Tune in the radio.

10.  Verify that the battery voltage is supplied to antenna amplifier terminal B.

am6zzw00013495

•  If the battery voltage cannot be verified, inspect the audio unit and antenna feeder.

•  If the battery voltage can be verified, go to the feeder line inspection.

Feeder line inspection

1.  Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-D 2.2].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5].) (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION [SKYACTIV-G 2.0, SKYACTIV-G 2.5 (WITHOUT i-stop)].)

2.  Remove the center roof antenna. (See CENTER ROOF ANTENNA REMOVAL/INSTALLATION.)

3.  Verify that there is no continuity between center roof antenna sections A’ and B.

am6zzw00013496

•  If there is continuity, replace the center roof antenna.

4.  Install the center roof antenna.

5.  Verify that the continuity between the center roof antenna terminals is as indicated in the table.

am6zzw00013497

•  If the continuity is not as indicated in the table, verify the installation condition of the center roof antenna installation nut.

am6zzw00013498

•  If the installation condition of the center roof antenna installation nut is normal, replace the center roof antenna.